Weber 32/36 Dgv Carburettor For Ford 1.6 Ohc'pinto' Engine

  
WEBER 32/36 DGV CARBURETTOR FOR FORD 1.6 OHC'PINTO' ENGINE. Weber 32/36 DGV progressive carburettor. Genuine Weber, made in Spain. Manual choke replacement carburettor kit to suit the Crossflow and Pinto 1.6 engined versions of Ford Capri, Cortina, Escort and Granada models manufactured in the late 1970's and early 1980s. Manual choke mechanism fitted (Pull cable type).

The carburettor will start & run your engine safely. Further, refined calibration can be obtained from having your car tuned on a rolling road dynamometer. Weber 32/36 DGV carburettor Choke cable and fitting kit Water hose by pass kit Fuel pipe and return to tank adaptor In line fuel filter Manifold heat spacer/gasket Fitting instructions. 140 Primary Main jets 135 Secondary Main jets 160 Primary Air correctors 165 Secondary Air correctors 50 Primary Idle jet 55 Secondary Idle jet 200 Float valve 50 Pump jet. WEBER 32/36 DGV Carburettor centre-to-centre mounting stud dimensions: 46 x 93mm Check the mounting stud spacing on your intake manifold to confirm it will accept this WEBER.

Several manifold/carburettor combinations can be found on Pintos and crossflows, and not all of them are interchangeable. If your stud mounting dimensions are approximately 46 x 93mm then you can use this kit to convert your motor. Item location: DY5 3UP, United Kingdom. Excludes: Afghanistan, Libya, Nauru, Russian Federation, Somalia, Ukraine, Yemen.